Motogadget mo.flash, electronic flasher relay

The mo.flash is by far the smallest load-independent flasher relay on the market. It doesn't get any smaller or simpler than this. The flasher unit mo.flash replaces all conventional flasher relays.

Features

• Ultra small and lightweight, practically just one piece of cable with a tiny candy-sized device  
• Ideal for custom bikes and conversions with limited space - clunky standard flasher relays or load resistors are a thing of the past
• Can be routed e.g. in handlebar tube, frame tube or wiring harness
• Almost load independent (min. 1 Watt)
• Works completely with digital semiconductor technology. Control via microprocessor. No mechanics, no coils, no contacts
• Always constant and correct flashing frequency therefore suitable for almost all LED turn signals, all micro turn signals, halogen turn signals, 10 watt turn signals, 21 watt turn signals   
• Works e.g. with 4 turn signals or 2 handlebar end turn signals
• Immediate, lossless, brighter glow of the turn signals
• Super easy connection with only two cables - simply connect in series
• Absolutely waterproof and vibration resistant because completely encapsulated
• Short circuit proof, automatic overload protection. Switches up to 100 watts of power.
• No heat development during operation
• Operating voltage already from 5V to 18V
• Also suitable for 6 V flasher
• Quality 'made in Germany' - by motogadget

Specifications

• Housing L x W x H: 18 x 13 x 9.5 mm
• Length of connection cable: approx. 2 x 50 mm
• Weight: approx. 4 gr.

Notes

• The mo.flash replaces a conventional flasher relay. This flasher relay is usually located BEFORE the flasher switch, as seen in the circuit. The easiest way to install the mo.flash is to locate the original relay and simply replace it with the mo.flash.
• The mo.flash CANNOT replace the push button control when using push button armatures. See mo.relay+ product if you are looking for a flasher relay for push buttons.
• On recent Harley-Davidson™ models, the turn signal control is controlled by a special module (TSM/TSSM). The mo.flash can unfortunately NOT replace or supplement these modules.
• If you are looking for a flasher relay with automatic switch-off, please have a look at mo.stop.