Highsider Typ 6, LED headlight insert 5 3/4 inch

E-approved

HIGHSIDER 5 3/4 inch LED main headlight insert TYPE 6, E-approved.

This round, chrome reflector has high beam, low beam, daytime running lights and a parking light ring. The daytime running light is centered in the strip and the low beam shines in the upper half from the insert. When the high beam is on, both halves illuminate.

HIGHSIDER highlights - give your bike your unmistakable style! The unusual design and perfect technology of the HIGHSIDER headlight series will definitely make your bike a highlight!

Dimensions

• Diameter A = 143 mm
• Diameter GA = 133 mm
• Diameter I = 131 mm, T = 70 mm, R = 13 mm
• Cable length: 400 mm

Connections

• 3 pin connector
• White = low beam (+)
• Blue = High beam (+)
• Green = Ground (-)
• Red = TFL/DRL (+) to ignition positive
• Brown = position light (+)

Scope of delivery

• 1 piece main headlight insert, E-approved, incl. 1x connector housing

Note

The daytime running light can also be used on vehicles without a light switch. For this purpose, the following components are required, for example:

• 240-044 LIGHT ON/OFF SWITCH
• 208-108 HIGHSIDER DRL CONTROL- BOX CB1 (switches between low beam and daytime running light).

If it happens with this product in connection with the HIGHSIDER DRL CONTROL- BOX CB1 (208-108) that the headlight does not switch daytime running light after starting the engine, please proceed as follows:

• Install the enclosed 120 Ohm resistor as indicated in the instructions
• Now the headlight should also switch the daytime running light