Highsider Apollo Modul, LED 3in1 taillight/turn signal

E-approved

HIGHSIDER APOLLO MODULE 3in1 LED taillight, brake light, turn signal, E-approved for rear.

LED tail light, brake light, turn signal module suitable for mounting or surface mounting, black aluminum ring with tinted glass. In the center are 2 very bright SMD installed. The outer ring consists of COBs (Chip On Board). In this technique, the semiconductor (without housing) is glued directly to a printed circuit board. This module comes with a black anodized aluminum ring that fits over the base body.

The best is saved for last - HIGHSIDER's taillight and taillight/turn signal series give you the safety you need and the look you want - whether you're a cruiser, sport bike or speedster.

Dimensions

• A1: 13 mm
• A2: 9 mm
• D1: 22 mm
• D2: 20 mm
• Threaded bolt: M8, length 12 mm

Connections

• Black cable = ground (-)
• Yellow cable = rear light (+)
• Red cable = brake light (+)
• Blue cable = turn signal (+)

Scope of delivery

• 1 pair of tail light, brake light, turn signal 254-170

Note

• The unit can be installed flat without an aluminum ring, so that only the lens is visible. For this purpose, a 20 mm wide hole must be drilled.
• Alternatively, the unit is mounted with the Aluring on e.g. a retaining plate on the vehicle.