Tecmate OptiMate SAE to USB, charging adapter

The portable & compact O-100 SAE to USB 2400 mA charger for safe and fast charging of any USB device, including your phone, camera or GPS.

Features

• Smart 2400 mA USB charger, with standby mode & vehicle battery monitor
• Connects to battery lead with industry standard SAE 2-pin connector – Seals perfectly when mated with OptiMate SAE!
• Charges 1x USB device with up to 2400 mA current available (or get optional O-110 USB splitter and charge 2 devices). – Charge current adapts to connected device for safe recharging.
• Creates weatherproof seal against inserted USB cable, or "rideproof" cap seals when not in use – worry free phone, camera or GPS charging in any weather!
• Built-in protection turns off USB charging & prevents your parked vehicle’s LFP (LiFePO4) or AGM (Pb)battery from draining – starts back up when vehicle engine fires up
• Monitors and displays parked vehicle’s battery status – indicates battery is "start ready" at the blink of an LED!
• Fully enclosed electronic circuitry with multiple LEDs, unique seal and cap design for USB socket; use any USB cable, seals when inserted
• 3-year limited replacement warranty

Technical specifications

• Length: 8 cm
• Charge connector (input): 2-pin SAE
• Charge connector (output): 1x USB
• Charging Amps: 2400 mA / 5 V
• Fully automatic operation
• Input: Vehicle 12 V system with 12 V lead-acid or 12.8 V lithium battery

Smart stand-by mode

• USB output turns off 1 hour after engine stopped or immediately if voltage reduces below 12.4 V
• 2 LED battery monitor (when USB output off)  – battery status is displayed every 5 seconds
• Short circuit, overheat, over-voltage protection

Operation (Voltage)

• USB on - 13.3 V to 18 V – unlimited USB output, USB LED on, delivers USB power when vehicle engine is charging battery
• USB 1 hour - 12.4 V to 13.3 V – 1 hour USB output, USB LED on, go to standby mode after 1 hour or voltage < 12.4 V
• Standby mode – monitoring voltage, turns back on if vehicle battery voltage increases above 13.3 V
• AGM / LFP monitor - LED blink every 5 seconds if battery charge ≥ 50%, sufficient to start vehicle engine
• LED LFP: 13.1 V to 13.3 V
• LED AGM: 12.4 V to 13.1 V
• No LED < 12.4 V
• Off ≤ 9 V