Tecmate OptiMate SAE/USB Monitor, charger

OptiMate O-108 V2.

The fully enclosed SAE to USB 3300 mA charger with 200 cm cable allows safe and fast USB charging of any device mounted on the outside of the handlebar or in your tank bag or hard case. The cable goes where USB charging is required.

Charge your phone, GPS, camera and tablet with your weatherproof charger on your motorcycle or up to 80″ / 200 cm away from a 12 V supply.

Features

• Connects to battery cable with industry standard 2-pin SAE connector
• Inline gasket makes 12 V connection weatherproof!
• Charges 1x USB device with up to 3300 mA current (or optionally charge 2 devices with O-110 USB splitter).
• Charging current adjusts to connected device for safe charging.
• Weatherproof USB charging port, easily attaches to handlebar, fork or brake/clutch fitting with cable tie
• USB cable inserted is sealed, for charging in all weather conditions
• Built-in protection interrupts USB charging and prevents your parked vehicle's LFP (LiFePO4) or AGM (Pb) battery from discharging
• Restarts as soon as the vehicle engine starts
• Monitors and displays the battery status of the parked vehicle
• Indicates that the battery is "ready to start" by flashing an LED
• Length: 80″ / 200 cm
• Charge connector (input): 2-pin SAE
• Power (input): Vehicle 12 V system with 12 V lead-acid or 12.8 V lithium battery
• Charge connector (output): 1x USB
• Power (output): 3300 mA @ 5 V
• Operation:  fully automatic
• Vehicle battery protection: Low input (<12.4 V) auto-off protects vehicle battery from total discharge. Supply range: 12.4 to 16 V DC
• Turns on if vehicle battery voltage increases above 13.3 V
• 2 LED battery monitor
• Short circuit, overheat, over-voltage protection
• Cable rating: SPT-1
• Use: -20 °C/-4 °F very low temperature, remains flexible at ‘below freezing’ temperatures
• Style: Fully enclosed electronic circuitry with multiple LEDs, unique seal and cap design for USB socket ; use any USB cable, seals when inserted

Operation (Voltage)

• USB on – 13.3 V to 18 V – unlimited USB output, USB LED on. Delivers USB power when vehicle engine is charging battery
• USB 1 hour – 12.4 V to 13.3 V – 1 hour USB output, USB LED on. Go to standby mode after 1 hour or voltage < 12.4 V
• Standby mode – monitoring voltage, turns back on if vehicle battery voltage increases above 13.3 V
• AGM / LFP monitor – LED blink every 5 seconds if battery charge ≥ 50% , sufficient to start vehicle engine
• LED LFP: 13.1 V to 13.3 V
• LED AGM: 12.4 V to 13.1 V
• No LED < 12.4 V
• Off ≤ 9 V